Electric Kiln Conversion

It occurred to me that I didnt do a proper post about the kiln conversion. Been a bit behind lately I guess.

So here it is.

I found this information on the Ward Burner site which is a fantastic resource. You cant even buy a burner without talking to someone and going through the entire process and calculations so that what they sell you is specifically designed to do what you want to do. They are fantastic to work with. The MR100 burner with the regulator that pushes 11WC” of pressure. Its the standard off of any tank. I got this burner because it pushes more BTU and it is bad to the BONE!

burner

The important information:

Burner port is 1″ wider than the burner dimentions

Exhaust port is 2″ wider than the burner dimentions

First put on your mask. DO THIS! You dont want to breathe this stuff. It might not kill you right away but it would be a shame to end your ceramics career and life before your have to.

2015-09-15_193112998_590E6_iOS

It starts off like this.

2015-07-19_005233000_AE39C_iOS

Get it cleaned out. Vaccum it out with a shop vac and get the inevitable junk out of it.

Then get in there and remove the dangly bits and the wires and controller if it has one.

2015-07-20_202232169_C92D4_iOS

Then carefully remove the elements. Those were the most troublesome part as they kept trying to break off the lip of the fragile soft brick.

2015-07-20_223544286_84666_iOS

For the exhaust I cut the soft brick of the lid using a small saw. I drew the template using a straight edge ruler and a permanent marker but just about anything will do. This shows the width as 2″ larger than the burner port.

2015-07-24_225716313_80A93_iOS

I intentionally cut my exhaust width wise to the correct dimensions but cut it longer than necessary so that I could put a kiln shelf or two on top and regulate how much air gets in or out as well as move the port to the font or the back of the kiln during firing.

Cutting the burner port itself was a challenge due to the sheet metal housing. I ended up drilling a hundred small holes and then doing my best to clip off the sharp edges using some wire cutters.

2015-07-24_231538133_54552_iOS

Make sure you have a tank of LP Propane, depending on how fast and how hot you are firing you might need a larger tank. I opted for the 100lb tank and I have another 2 firings out of it before I have to refill it. You can see the vapor line of condensation indicating the level of fuel left in the tank. A 20lb BBQ tank would most likely freeze up before I got to temperature.

2015-08-20_143137000_60705_iOS(1)

Spark it up and make sure it works.

2015-08-25_223913025_A7B51_iOS

Then go to town!

IMG_7788

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s